Hi,
I have a cluster its repairing too frequently ( within Mins) as the data is very less.
Its starting repair cycle every one min.
First I changed below to 100
time_to_completion_target_percentage = 100
But the time has only increased a bit where its completing in 20 mins now. Is there a way we can control where the repair should run 4 or 5times in a day?
Later I tried with by setting min_repair_time = 7200 to see if it repairs in 2 hours ( assuming min_repair_time spans total repair time to 2 hours
(7200 sec)
max_parallel_repairs = 9
max_pending_repairs = 90
min_repair_time = 7200
single_repair_timeout = 36000
tokenranges_http_timeout = 300
time_to_completion_target_percentage = 0
But the subrange repair didn't even finish and I see below un event log
| 12/16/2020, 5:11PM UTC | Info | Launching incremental job with 0 tasks, 0 bytes, 0:00:52 time to complete (Wed Dec 16 17:12:16 UTC 2020) and 'min_repair_time' of 7200 seconds per task, with 0:00:52 time remaining. | - |
| 12/16/2020, 5:06PM UTC | Info | Rolling incremental repair: there is nothing currently to repair, will try again after sleeping for 300 seconds. This period of time is configurable with [repair_service].restart_period. | - |
| 12/16/2020, 4:06PM UTC | Info | Launching incremental job with 0 tasks, 0 bytes, 0:00:52 time to complete (Wed Dec 16 16:07:16 UTC 2020) and 'min_repair_time' of 7200 seconds per task, with 0:00:52 time remaining. |
Is there any ideal settings to run the repair every N hours?
